How to Get the Most Out of Your Dynamic Air Cleaner

Dear Dynamic Customer;

In case you have been wondering just how much good the Dynamic is actually doing here is some information about air cleaning in general and the Dynamic technology!
 

• How to judge its effectiveness - Due to the unique loading characteristics of polarized media (7000 volts in a three layered pad) the place to look first for evidence is the inside of the pad. The fact that the voltage is applied first to the middle carbon layer causes it to load from the inside out. Normally we look at the outside of any filter to determine if we see lots of dust caked on it. This is only a partial method so follow this method of examination and you will increase your awareness of what is actually going on.
   

• Cut a corner of the pad off with scissors when changing the pad. Then pull back the layers to examine the middle carbon layer for dust. Flick the carbon layer and watch as the dust comes out into the air.
   

• Realize what you are looking at by understanding that 98% of the particles in the air are invisible to the naked eye. That means the large particles you see on the outside of any filter are only a small fraction of the problem. (see the micron chart)
   

• Dynamic Difference - Here is the major difference between the Dynamic Electronic (7000 Volt) Air Cleaner and "Paper Filter." Magnetism! The voltage creates a polarization of + and - charges on the fibers and the carbon causing the charged air particles to attract to the charged fibers/carbon. This is the only way to effectively capture the sub micron (invisible) particles. All of the bacteria and viruses and vast majority of health injurious pollutants (including gases) are in this invisible realm.
   

• How do I know the bacteria and viruses are being killed - The only way is to examine the test data done by independence laboratories and i will gladly send it to you. There really is no way to visually determine these facts as the invisibility prevents the naked eye from making such an assessment. (See the micron chart)

How to Increase Efficiency of Your Dynamic Air Cleaner

1. Run the furnace blower 24/7 or as much as you can. Go to the "Fan On" position at your thermostat settings. The more air that goes through it will obviously increase the efficiency of the Dynamic or any other filter for that matter.
    

2. Change the pad every 3 months unless you are not running the furnace at all for periods of time controlled by the weather or your schedule.
    

3. Remove excess clutter from the basement, cardboard, animal dander. Open your windows only when necessary. Be aware of high air pollution days.
    

4. Call John Hendrickson at 1-800-916-7873 for any questions or comments.  Thank you for your business and trust. We are committed to indoor air quality!

Whole House Electronic
Air Cleaner

Dynamic Replacement Filters

"LOWEST PRICE ON THE INTERNET!!!"